Husqvarna Washer for 395XP Front Anti-Vibration Mount

This Husqvarna 395XP anti vibration washer is part of the front AV mount that holds the spring between the handle and the engine. A lost or worn washer can let the spring shift and the handle loosen.

Small part, important job

On a heavy saw like the 395XP, the anti-vibration system takes a lot of load. If the washer goes missing during a repair or wears through, the spring can work loose, the handle rattles, and vibration increases.

It's smart to replace washers with the springs. Find springs and other parts in our power equipment parts.

Washers and small hardware are easy to lose during a repair, and a missing one is enough to make the handle loose. Ordering a spare with your springs saves a second trip. The part costs very little, but a handle that shifts in your grip makes precise cuts harder.

Fitting it

Use the parts diagram to confirm the position and the order of the washer, spring, and screw. Tighten fasteners to spec.

After the repair, check the handle for slop before running the saw, and inspect the other AV mounts at the same time.

If you run several 395XP saws, keep a small kit of AV springs, washers, and screws in the shop. Check all mounts at each service, especially on saws that run long bars. A loose handle increases vibration and makes the saw harder to control safely. Hand-tighten first, then torque, so the spring seats evenly without twisting between the handle and the engine bracket.