Petzl Replacement Bridge

The Petzl replacement bridge lets you swap out a worn or damaged bridge on a Petzl Sequoia or Sequoia SRT saddle instead of retiring the whole harness. It is a wear part, and on a saddle that gets climbed every day it is often the first thing to need replacing.

Why bridges wear out

The bridge takes every load you put on the saddle and it slides through a rope-wrench tether, a hitch-climber pulley, or a carabiner hundreds of times a day. Sap, bark grit, and sawdust work into the fibers and act like sandpaper. A bridge that looks fuzzy, glazed, or flat in spots is telling you it is time.

Replacing the bridge is far cheaper than a new harness, and the rest of a Sequoia often has plenty of life left. Keep a spare in the truck so a bad inspection does not end the day.

On a Sequoia the bridge also sets how the saddle sits when you lean back in your lanyard or hang in the climbing line. A bridge that has stretched, been cut, or picked up hard spots changes that feel, and it is a sign the rest of the saddle deserves a close look too.

Matching the part and checking it

Petzl has offered bridges in different lengths and versions over the years, so confirm your saddle model, size, and the bridge length you want before ordering. Other bridges and shoulder harnesses are in saddle parts and shoulder harnesses.

Install it exactly as Petzl's instructions show, then hang-test low and close to the ground before climbing. Life-support gear must meet the applicable standard, follow ANSI Z133 and the manufacturer's instructions, and be inspected before every climb. Get trained before you rely on it.