CT Quick Roll Hand Ascender

The CT Quick Roll hand ascender pairs a handled rope clamp with a built-in pulley. That makes it useful both for ascending a stationary rope and for building a quick progress-capture haul system.

Two jobs in one tool

As a hand ascender, the Quick Roll grips a stationary line while you stand in a foot loop or push off a foot ascender. Because the pulley sits right below the cam, you can also run a rope back through it to build a simple haul or tensioning system without adding a separate pulley.

It can also help on the ground when you need to tension a line or haul a rope bag up to a climber. Using one tool for both jobs saves weight on your saddle, but make sure every use fits within the loads and roles the manufacturer lists. Keep climbing gear and rigging gear separate when you can.

Check the rope diameter range and approved uses in Climbing Technology's instructions. See our ascent and descent gear for devices that work with it.

Safe use and inspection

A hand ascender is part of a system. Never rely on it alone; stay connected with your primary device and a backup as instructed.

Treat it as life-support gear: follow the manufacturer's instructions, check it before every climb, and retire it after a hard fall, a drop onto a hard surface, or any damage you can't explain. Use it within an ANSI Z133 program and only after proper training.

Keep the cam teeth clean and check the spring action each time you pick it up. A worn or clogged cam can slip under load, and that is a reason to retire the device rather than keep using it.